WAGNER WALL EXTRA I-SPRAY 1800 Mode D'emploi page 12

GB
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
2. If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 %
until the feed rate meets your requirements.
Adjusting the material quantity
Very high quantities can be processed with this attachment. To prevent paint runs on the
object, first adjust the paint quantity by spraying onto a piece of card or paper from the
same spraying distance.
First turn the adjustment knob (Fig. 1, Item 9) fully to the left (-) and then slowly increase
the material quantity to the desired amount by turning it to the right (+).
An average flow setting provides the best result for most wall paints.
i
Selecting the Spray Setting (Fig. 2)
WARNING! Danger of injury! Never pull the trigger while adjusting the air
cap.
2 different spray jet shapes can be set by turning the adjustment ring (fig. 2, 1)
Fig. 3 A = vertical flat jet
Fig. 3 B = horizontal flat jet 
Use the red adjustment lever to also switch between a wide ( )
and a narrow ( ) spray jet.
Spray Technique (fig. 4)
The spray movement should come from the arm, not just from the wrist. This ensures that
a uniform distance is maintained between the spray gun and the spray surface during the
spray operation. Select a distance of 20-30 cm, depending on the desired spray jet width.
Important: Start at the edge of the area to be sprayed. Start the spray movement first
8
Thinning recommendation
for horizontal surfaces

for vertical surfaces
Wall Extra I-Spray 1800
dilute by 0-10%