Yakima PowderHound Instructions De Montage page 3

ASSEMBLE.
• Insert base
screw
through hole
in pad.
• Position slider
top onto screw.
REPEAT ASSEMBLY
FOR REMAINING
HARDWARE.
SLIDE CARRIER ASSEMBLY ONTO CROSSBAR
FACTORY BARS
1033546D-3/18
ATTACH UPPER BAIL
TO SLIDER TOP.
• Align the base screw with
square nut (inside upper
bail.)
• Use hex wrench
to engage the
screw and nut.
• Do not tighten yet.
CLOSE CARRIER WITH
FIRM PRESSURE.
ROUND BARS
MOVE SLIDING
BAIL TO EXPOSE
SCREW HOLES.
INSERT SECOND BAIL
SCREW THROUGH
UPPER BAIL ONLY.
SQUARE BARS
If desired, attach vinyl
pads to underside
of factory bars to
protect finish.