For A Foot Or Calf Massage - Human Touch HT-5020 Manuel D'utilisation Et D'entretien

take a seat
1. Push the Recline Mode Selector
With the backrest fully inclined, push the Recline Mode Selector forward to the Full Recline setting, or pull backward
to the Relax Mode setting.
IMPORTANT: The Recline Mode Selector will not move unless the backrest is in the full upright position. To release
the Recline Mode Selector, press the incline button on the remote control until the backrest is fully inclined.
Full Recline
2. Press and hold the Recline button
The backrest reclines and the footrest deploys until each reaches the
selected Recline Mode position, or you release the Recline button.
Recline
Posture buttons
When changing backrest or foot and calf massager direction, there is a slight pause while the chair gears shift. This is perfectly normal.
humantouch.com
Relax Mode
8

FOR A FOOT OR CALF MASSAGE

1. Deploy the foot and calf massager
To prepare for a foot or calf massage, you must first rotate
the footrest to position the massage wells on top.
Pull up on the footrest rotation release handle (located on the right-hand
side of the footrest).
For a calf massage, rotate the footrest away from the chair until it clicks
into position with the foot and calf massager facing up. Do not force the
rotation of the footrest past the point at which it clicks to lock. Excess
force may damage the mechanism.
For a foot massage, rotate the footrest away from the chair just until the
foot and calf massager is facing up. Do not rotate it so far that it clicks
into position; the footrest should be moving freely for a foot massage.
2. Insert your feet or calves
Do not stand or sit on the foot and calf massager.
For an easier exit, incline the chair to a full upright position before getting out of it.
Make sure the area behind/underneath the footrest is clear of any obstructions before inclining the chair.
Use the Power Incline button to lower the footrest and return the backrest to a full upright position.
9