Lanaform Bali Mode D'emploi page 6

EN
FR NL DE ES IT PL CS SK HU SL HR RU BG SV AR
Maintenance
We recommend:
1 Preferably using boiled and cooled water
for each use,
2 Cleaning the reservoir every 2 days and
cleaning the transducer every week,
3 Changing the water in the reservoir every
2 days,
4 Cleaning the device and making sure that all
its parts are completely dry when it is not in use.
Problem
No steam, no light indicators
Mist has an unusual smell
Low intensity
6
/ 60 "Bali"
To clean the transducer
1 Put 2 to 5 drops of vinegar on its surface and
leave them there for 2 to 5 minutes.
2 Brush the foam off the surface with a soft
brush. Do not use a hard tool to scrape the
surface.
3 Rinse the reservoir of the base in clean water.
4 Do not use soap, solvent or spray cleaner to
clean the transducer.
TROUBLESHOOTING
Possible causes
If there is no light
The water level in the reservoir is too low
The temperature of the unit is too low
The water has been standing in the reservoir
too long
Too much/little water in the reservoir
Sediment on the transducer
The water is too cold
The water is not clean
To clean the reservoir
1 Clean the reservoir with water using a soft
cloth and vinegar if there are foam or limescale
deposits on the inside.
2 Rinse the reservoir in clean water.
Storage
After cleaning and drying the device, store it
in a dry, cool place out of the reach of children.
TROUBLESHOOTING
In the event of a malfunction, under normal condi-
tions of use, please refer to the following chart:
Solution
Check the mode chosen If you chose continuous
diffusion with ambient light, check that the device
is plugged in and no power outage has occurred
Add water to the reservoir
Place the unit in a room at ambient temperature
for half an hour prior to use
Clean the reservoir and pour fresh water into it
Empty the water out of the reservoir or add
water to it
Clean the transducer
Use water that is at room temperature
Clean the reservoir and pour fresh water into it