Warning! Due to the intelligent energy management system, the motor starts after a delay.
After switching off the equipment, the cable continues to turn for several seconds. Do not
touch the moving blade. There is a risk of injury.
Charging the battery
Do not expose the battery to extreme conditions such as heat or impact. Risk of injury from
escaping electrolytic solution! After eye / skin contact, rinse the affected areas with water or a
neutralizer and consult a doctor.
Charger the battery in a dry room only. Prior
to attaching the charger, check that the battery's outer surface is clean and dry. There is a risk
of injury due to electric shock.
Only use the charger from the package to charge the battery.
- Charge the battery before the first time of use. Do not briefly charge the battery several time in a
row.
- If a fully recharged battery lasts for considerably shorter operating times, the battery is used up and
needs to be replaced.
- Always take heed of the applicable safety instructions as well as the environmental protection
regulations and information.
- The warranty excludes all defects caused by improper handling.
Insert / remove rechargeable battery
Switch off the apparatus, remove the ignition key (10) and wait for the blades to come to a
standstill.
The battery is made up of two battery packs. Before you insert the battery in the machine, you must
insert the battery packs in holder first. (see Fig. 5).
1.
To insert the battery (9) push the battery along the guide rail into the appliance. It locks into
place audibly.
2.
To remove the battery (9) from the appliance, press the release button and pull the battery
out.
Recharging the battery
Switch off the apparatus, remove the ignition key (10) and wait for the blades to come to a
standstill.
Allow a freshly charged battery (9) to cool down for approx.. 15 minutes before inserting it into the
battery charger (19).
6.
Remove the battery (9) from the appliance.
7.
Slide the rechargeable battery (9) onto the charger (19). It locks into place audibly.
8.
Plug the charger (19) into an electrical outlet.
9.
After the charging process, disconnect the charger (19) from the main supply.
10.
Press the release buttons on the battery (9) and pull the battery (9) out of the charger (19).
56