Atlantic EGEO Notice D'utilisation Et D'installation page 40

•
The ventilation system and the openings operate correctly and
are not obstructed.
•
If an indirect refrigerant circuit is used, the presence of
refrigerant fluid in the secondary circuit must be checked;
•
The markings on the equipment must always be visible and
legible. Any markings and identifications which are illegible must
be corrected.
•
The pipework and the components of the refrigerant circuit are
installed in a position where it is unlikely that they are exposed to
substances likely to corrode components containing refrigerant
fluid, unless the components are designed from materials which
are naturally resistant to corrosion or suitably protected from
such corrosion.
2. Checking the electrical equipment
The repair and maintenance of electrical components must include
initial safety checks and inspection procedures of components. If a
fault which could compromise safety is found, then no power supply
must be connected to the circuit until this problem is dealt with in a
satisfactory manner. If the fault cannot be dealt with immediately,
but it is necessary to continue the intervention, a suitable temporary
solution must be used.
This must be reported to the equipment owner so that all the parties
concerned are aware.
The initial safety checks must include:
•
That the condensers are discharged: this must be performed
safely to avoid the risk of sparks
•
That no live components and live electrical cables are exposed
when charging, recovering or purging the circuit
•
That there is continuity of the earth connection
38