Technical Data - Diamond BRET/2G-R Notice D'utilisation Et D'installation

Instructions for use and installation
Gas crepe machine
USE
Description of the appliance
Gas crepe machines are supplied with 1 or 2 steel griddles, 350 or 400 mm in diameter.
The griddles are heated by star – shaped burners which ensure uniform heat distribution.
The crepes machines are fitted with a pull – out stainless steel shelf.
These appliances are for professional use and must therefore be used by qualified personnel.
They must be installed in accordance with current regulations by a qualified installer.
Unpack the appliance carefully from its original packaging. Place it on a flat surface.
The identification plate is located on the back of the appliance.
Dimensions and capacity
Appliance Dimensions
350 G 450x485x240
400 G 450x485x240
350 GD 860x485x240
400 GD 860x485x240

Technical data

Appareil Débit calorifique
350 G
400 G
350 GD
400 GD
Weight Number of Griddle
griddles dimensons
16 kg 1 350mm
18.5 kg 1 400mm
32 kg 2 350mm
37 kg 2 400mm
Nombre de brûleurs
3.2 kW 1
3.2 kW 1
6.4 kW 2
6.4 kW 2
Operation
Lighting Presse the knob in for a few seconds
Place a flame close to the burner
Keep the knob pressed in for a few more seconds
The burner will then remain lit, now adjust the appliance to the setting required.
There is an in-built double safety feature :
If one of the points of the burners is blown out by a draught of air, the star located at the centre
of the burners acts as a flame spreader towards the points which have gone out (patented
system). This may occur during operation on the low flame setting.
A thermocouple cuts off the gas supply if one of the burners goes out.
The appliance has a factory-adjusted low flame setting.
Care and maintenance
Your appliance should be cleaned regulary with a damp sponge.
Do not clean your appliance under running water : water entering the system might damage it.
For improved service, we advise that periodic maintenance checks are carried out by a
qualified installer.
Your appliance can operate on liquid petroleum gas or natural gas. To change from one gas to
another requires the intervention of a qualified installer.
For appliances used in Belgium and Germany, changing from one gas to another is the sole
responsibility of the manufacturer or his local agent.
Installation
NB : The side panels of your appliance must not be placed next to a wall or partition made
from a combustible material, otherwise, they should be covered in an effective heat insulating
material.
A distance of 10 cm from the partition is deemed sufficient.