Table des Matières
Publicité
26
Additions/Changes Checklist
Squares are black when they have been added to the manual,
they do not apply) and remain
1) Under Framing for all products which can be framed:
Note: In order to avoid the possibility of exposed insulation or vapour barrier coming in contact with the
fireplace body, it is recommended that the walls of the fireplace enclosure be "finished" (ie: drywall/sheetrock), as you
would finish any other outside wall of a home. This will ensure that clearance to combustibles is maintained within the
cavity.
2) Under - General Instructions : after....."to conform with local codes"........ - for all gas fireplaces :
All gas products:
Installation practices vary from region to region and it is important to know the specifics that apply to your
ie: in Massachusetts State:
The fireplace damper must be removed or welded in the open position prior to installation of a fireplace insert.
The appliance off valve must be a "T" handle gas cock.
The flexible connector must not be longer than 36 inches.
The appliance is not approved for installation in a bedroom or bathroom unless the unit is a direct-vent.
3) To all Napoleon and Continental Manuals:
1) New Logos
2) New e-mail and web addresses
ask@napoleon.on.ca
ask@continentalfire.com
3) Change street address from 9 to 24
4) To all manuals under "Blower Installation".
Drywall dust will penetrate into blower bearings causing irrepairable damage and must be prevented from coming into
contact with the blower or its compartment.
Any damage resulting from this condition is not covered by the warranty policy.
W415-0100 /B / 04.12.01
green
if they need to be added. This page will be printed with every manual.
www.napoleonfireplaces.com
www.continentalfireplaces.com
Wolf Steel Ltd.,
Barrie, ON., Canada L4M 4Y8 (705)721-1212
red
when they do not need to be added (because
24
Napoleon Rd.,
area,
Publicité
Table des Matières
