Maintenance And Storage - Ribimex Ribitech PRKIT92FP Manuel D'instructions Et D'utilisation

4.7- Variable speed control (5)
Light pressure on the ON/OFF trigger switch (6) results in low speed, allowing drilling to begin in a
smooth, controlled manner. Further pressure on the switch results in an increase in speed.
The desired speed can be pre-selected with the thumb wheel (5) or also possible during operation.
The rotational speed to be used depends upon the material being drilled.
4.8- Switching on and off (6)
To start the machine: squeeze the ON / OFF trigger switch (6).
This machine is fitted with a locking button (7) allowing a "continuous running".
Start the machine then press on the locking button (7) for "continuous running" located on the side of
the handle (8), release the ON / OFF trigger.
The machine will now run continuously without the need to maintain pressure on the ON / OFF
trigger switch.
To stop the machine: squeeze then release the ON / OFF trigger switch.
V. OPERATION
5.1- Intended use
- The product is intended for indoor domestic use.
- The product is intended for forward and reverse screwing; and for impact drilling
5.2- Operation:
1. Connect product to a power source (refer to characteristics on product).
2. Wear appropriate protective equipment.
3. Insert bit or accessory in the chuck.
4. Prepare material for work
5. Secure material, if necessary.
Do not use your own weight or body to hold material.
6. Firmly hold tool with both hands. Always maintain a balanced and secured position.
7. Place bit on material. Do not make sudden movements.
8. Press on trigger switch (6) to start operation.
To start the "continuous running", press on ON/OFF switch then on the locking button (7).
To stop the "continuous running", press again on ON/OFF switch.
9. Once work is finished, stop product by releasing the trigger switch (6).
Note: do not put down product until chuck has completely stopped rotating.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that product is disconnected form its
power source.
6.1- Cleaning
a) Clean the plastic parts with a soft and clean cloth.
Do not use aggressive cleansing agents (solvents, abrasive cleansers) or an abrasive sponge or any
sharp objects.
- Do not use any caustic chemicals to clean the plastics parts.
- Never put or immerse the product in water or any liquid, and ensure that water does not penetrate
the tool or the charger.
Never splash with water or clean with high pressure hose!
b) Clean chuck with a soft brush.
c) Clean ventilation holes with soft brush.
Page 17 of 18