Noise Level - Ribimex Ribitech PRKIT92FP Manuel D'instructions Et D'utilisation

(C) Special warnings when using the product
1. Become familiar with the controls and the proper use of the tool.
2. Keep children and bystanders away
Do not let bystanders touch the tool or its power cable or the extension cord.
All bystanders (esp. children) should be kept away from tool and work area.
Keep the product away from children or from their environment. Never allow children to operate the
tool. Children should be supervised to ensure that they do not play with the tool.
3. The use of this product is forbidden to children.
4. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
5.1. Do not use the tool in wet or damp conditions, areas. Keep work area free from tipping
hazards.
5.2. Do not work with materials containing asbestos.
5.3. Do not use tool to mix mortar, concrete, plaster
6. Never change the rotation direction of the chuck while the tool is still running. Ensure that the
chuck has come to a complete stop before changing rotation direction.
7. Never put down the tool unless the tool is switched off and the chuck has come to a complete
stop. Always stop the tool before putting it down (note: Ensure that chuck is no longer rotating when
you put down the tool).
8. Keep hands and other body parts well away from the workpiece while tool is in use.
Keep hands well away from the underside of the workpiece during use. Do not use your hands to
remove any dust, chips or other waste while the tool is in use. Do not touch the bit right after
operation, as it may be hot and cause burns. Never seize the chuck or bit during operation.
9. When using tool for screwing/unscrewing, place the screw bit on the screw head only when
power tool is switched off.
10. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Health defects resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
d. Health hazard resulting from dusts from materials containing harmful substances.
Wear hearing protection while operating the power tool.

10.1. Noise level

Wear ear protection
The measured values have been measured in accordance with a standard test method.
The measured values are mentioned in the characteristics table.
10.2. Vibrations level
The declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning! The vibration emission during actual use of the power tool can differ from the declared total
value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
11. Electrical Safety
Always check that the voltage of the power supply matches the voltage indicated on the tool's rating
plate.
Page 15 of 16