Getting Started - Ribimex Ribitech PRKIT92FP Manuel D'instructions Et D'utilisation

12. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
13. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected form its
power source.
4.1- Unpacking
Remove product from its packaging.
Check that tool and accessories are not damage
4.2- Inserting and removing a bit
Open chuck either electrically or manually.
Insert the selected drill/driver bit into the chuck (1).
Make sure that it is correctly inserted and centered.
Rotate the chuck outer ring until the drill/driver is gripped.
Using even torque tighten the chuck, either electrically or manually.
4.3- Auxiliary handle assembly (10)
To fit the side handle (10), unscrew the handle fully and remove the bolt from the clamping ring.
Pull open the clamping ring until it will pass over the chuck and locate on to the body of the drill.
Re-fit the bolt firmly and adjust the side handle as desired (either on the right or on the left).
4.4- Depth gauge assembly (2)
The drill is supplied with a depth stop (2) used for drilling holes to required depth.
Insert the depth stop (2) on the side of the auxiliary handle (10).
Measure back from the drill tip and move the depth stop back to the required measured depth.
The end of the depth stop will come into contact with the work surface when the required depth of
hole is reached.
4.5- Changing direction of rotation (4)
Set the direction of rotation lever (4) to the left to screw forward
Set the direction of rotation lever (4) to the right to reverse screw.
Note: the direction of rotation lever is locked when the On/Off trigger switch is activated.
Do not change the direction of rotation when the drill is running, wait till machine has come to a
complete stop.
4.6- Normal drill and hammer position
Put the selector switch (3) on top of the drill housing to Drill
according to your required work.
or Hammer rill symbol
d
Page 16 of 17