Handling And Use; Fitting The Car Cradle; Fitting The Vent Clip - Tronic TKHU 2 A2 Mode D'emploi

Handling and use

Fitting the car cradle

Unscrew the screw ring 4 anticlockwise from the
♦
car cradle .
Place the screw ring 4 over the ball joint 9 and
♦
press the ball joint 9 into the ball joint socket 5
(see fig . C) .
Screw the screw ring 4 clockwise onto the ball
♦
joint socket 5 until tight

Fitting the vent clip

Pull the lever 1 towards the car cradle and hold it
♦
in place .
Guide the hook 2 between two ventilation slots
♦
and hook it onto a ventilation slot .
Release the lever 1 slowly and, at the same time,
♦
place the two cut-outs 3 onto a ventilation slot .
Align the car cradle so that the two arms of the vent
♦
clip rest on the fitting . You can use the 360° rotating
ball joint 9 to adjust the car cradle horizontally
and vertically to suit your requirements . Loosen the
screw ring 4 a little to make it easier to adjust the
ball joint 9 .
TKHU 2 A2
GB │ IE │
13 ■