Environmental Protection - Worx LANDROID Mode D'emploi

®
Landroid is not operating at the
correct time.
®
Landroid cannot correctly dock
with the Charging Base
The Green light on the Charging
Base turns ON before charging
is complete.
®
Landroid runs outside the
boundary wire. Landroid
not mow an area within a
boundary wire zone. Landroid
reverses or rotates erratically
near the boundary wire.
®
Landroid wheels skid or
damage lawn.
20
®
Landroid exits the boundary
wire due to high speed when
going down a hill.

Environmental Protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Lawn Mowing Robot
The clock is not set to the correct
time.
Programmed cutting times for
®
Landroid are not correct.
Environmental influences
Poor connection caused by debris on
the Charging Strip.
The charging base is overheating, the
battery indication light flashes red.
The boundary wire of another
®
Landroid or another branded robotic
mower is positioned too closely.
The boundary wire has been installed
with tight corners.
®
does
In wet conditions, the boundary wire
®
electric signal may leak were wire has
been joined or repaired.
There is boundary wire electric signal
leakage due to broken insulation.
The cutting area is larger than the
allowable cutting area for Landroid
Foreign obstacles, such as twigs
and branches may be lodged under
®
Landroid .
The lawn is too wet.
The Boundary Wire is placed on a
slope steeper than 17% (10°).
Set the clock to the correct time.
Change the time settings for the mower to
start and stop.
®
Restart Landroid .
Clean the Contact Pins located on the
Charging Base and the Charging Strip on
®
Landroid using a cloth.
Place the charging base in a shady area or
wait until the temperature has cooled down.
Ensure your Landroid
has at least 0.5m of spacing between the
neighboring boundary wire.
Check the boundary wire to ensure the
corners are smooth.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
Repair damaged boundary wire insulation
with connectors.
Contact service agent.
®
.
Remove foreign objects from underside of
®
Landroid .
Wait until lawn has dried.
Reposition the Boundary Wire away from
slopes that are steeper than 17% (10°).
Please refer installation manual for details.
®
Boundary Wire
EN