Winter Hibernation; Replacing The Battery; Environmental Protection - Worx Landroid L WG792E.1 Mode D'emploi

7.4 Winter Hibernation

®
Your Landroid L will live longer and healthier if it is allowed to hibernate. So even though it is tough, we would recommend
that you store your Landroid
Before you prepare your Landroid
• Thoroughly clean your Landroid
• Fully charge the battery.
• Turn the mower off.
To maximize the battery life, it is recommended to fully charge the battery before storage during winter.
The Boundary Wire can be left in the ground although its ends should be protected, such as placed in a tin can with grease.
If the Charging Base is left outside for winter, leave the Boundary Wire connected.
NOTE: When bringing the Landroid
Pins (2) are clean, it is best to use a fine grade emery cloth. Then make sure the date and time are correct and send the
®
Landroid L back to what it loves doing: mowing.

7.5 Replacing the Battery

WARNING! Press the ON/OFF Key to OFF before attempting any adjustment, replacement or
repair.
If you need to replace the Battery, follow these steps:
1. Gently Turn your Landroid
2. Remove the six screws on the battery cover. (See Fig. N)
3. Take out the old battery. (See Fig. O)
4. Put in the new battery.
5. Firmly replace the screws.
14
N

Environmental Protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Lawn Mowing Robot
®
L in your shed or garage during the winter.
®
L for winter hibernation, we recommend you:
®
L.
®
L back to life after winter hibernation, make sure the Charging Strips (5) and Contact
®
L upside down.
O
EN