Fein Slugger JMC USA 90 Mode D'emploi page 16

OBJ_BUCH-0000000276-001.book Page 16 Monday, July 31, 2017 1:42 PM
en
16
Working instructions.
Fastening the handle (figure 7).
The handle for carrying the power tool can be
screwed in on the sides or on the top.
Feed (figure 8).
Work only with the absolutely required
amount of feed. Excessive feed can lead to
breakage of the application tool and loss of
the magnetic holding power.
Using a hex key, adjust the clearance between
and the feed resistance:
Turning clockwise = low clearance, higher
feed resistance
Turning counterclockwise = larger clearance,
lower feed resistance.
Fig. 7
Fig. 8
+
5 mm
-
3 mm