Rating Plate; Recommendations For Installation; General Notes - Diamond URB/P2 Manuel D'instructions

2

Rating Plate

The rating plate on our monobloc cooling units is located at the rear top right-side edge.
It includes the main technical data about the equipment and it identifies the MODEL and SERIAL NO., which are vital pieces of
information for any queries to the manufacturer.
The European directive on Waste from Electrical and Electronic Equipment (WEEE) specifies that, at the end of its life
cycle, the equipment and all of its components, subassemblies and consumable materials should be sent separately
for treatment for it to be destroyed, recycled or reused.
Do not put equipment with this symbol together with unseparated urban waste.
3

Recommendations for Installation

3.1 General Notes

Although the production and operation (as prove the enclosed test report) of each appliance is rigorously controlled during
manufacture, this does not exclude the possibility of damage caused in transit. The general condition of the appliance should
therefore be checked on arrival.
3.2 Placing
Remove the packaging or pallet carefully so that the equipment's surfaces are not damaged. Remove the PVC

protection.
The appliance should be installed away from heat sources (ex: heating appliances) and direct sunlight.

The air vents should never be covered or blocked - must be guaranteed free space to this areas, assuring a good air

circulation.
3.3 Installation
The following standards should always be bared in mind during installation:
Regulations concerning the buildings, and anti-fire standards.

Rules concerning accident prevention.

European standards into effect.

The appliance is supplied with a plug complying test standards, and with a regulation power cord long, enough to

allow connection to the electric socket.
The socket should be easily accessible and the right size for maximum consumption (see identification plate). It must have an

EARTH WIRE.
Never use sockets or plugs without an earth wire, nor should you use adapters or extensions.

For direct connections to the current, a circuit breaker must always be installed. This complies international standards.

MNS00007.02
TEC
Instruction Manual
a) Voltage (V)
c) Current (A)
e) Refrigeration gas
(ASHRAE)
N.º
Legend
b) Frequency (Hz)
d) Power (W)
f) Gas capacity (g)
MNS00007.02
8/27