Safety Instructions; Electrical Safety - Toolland TM 76025 Mode D'emploi

TM 76025
ANGLE GRINDER
TM 76025
WARNING
Read this manual carefully before using the
machine, for your own safety.
The following symbols are used throughout
this manual:
Always wear safety glasses.
Always wear a safety masque
against dust.
Always wear ear protection when
the sound level noise exceed
85dB(A).
Always wear protection gloves.
In accordance with the European
standards and directives.
Class II – The machine is double
insulated, an earthed wire is not
necessary.
Warning! Risk of personal injury
or damage of the tool or other
objects.

SAFETY INSTRUCTIONS


Do not use any other accessories than
grinding wheels.

Make sure that the speed stated on the
grinding wheel is larger or the same as
the speed of the angle grinder given on
the nameplate.

Do not cut workpieces requiring a
maximum depth of cut exceeding that of
the grinding wheel.

Make sure that the grinding wheel has
the correct dimensions and fits properly
on the spindle.

Treat grinding wheels with great care in
accordance with the instructions supplied
with the grinding wheel. Inspect the
grinding wheel before every use. Do not
use cracked or otherwise damaged
www.toolland.eu
grinding discs.

Make sure that the grinding wheel is
mounted in accordance with the
instructions.

After mounting the grinding wheel let the
machine run at no load speed in a safe
area. If the machine vibrates strongly or
if you see damages in the grinding wheel,
switch off the machine immediately and
try to establish the cause.

Do not use adapters or other aids to
mount grinding wheels with a different
spindle diameter.

Make sure that the workpiece is properly
supported or fixed.

Never use a cut-off wheel for deburring.

Make sure that sparks cannot hit any
persons or set flammable materials
alight.

Always wear safety goggles, hearing
protection and if necessary other
protectibe means, such as working
gloves, coat, hard hat, etc.

Mount the screening guard. Never use
the machine without screening guard
fitted.

Make sure that the ventilation openings
are kept clean. Especially when working
in a dusty environment.

Before removing dust always unplug the
tool.

Do not use brushes of metal or the like to
remove dust and avoid damaging the
internal parts.

Beware that after switching off the tool
the wheel continuous to rotate for a short
period.

ELECTRICAL SAFETY

Always check that the power supply
corresponds to the voltage on the rating
plate.
DESCRIPTION
Your angle grinder has been designed for
grinding and cutting masonry and steel.
1. On/off switch
2. Lock knob
3. Spindle
4. Guard
5. Side handle
MOUNTING AND REMOVING THE GUARD

First remove the grinding wheel as
described below.

Place the guard on the machine as
English
7