Cleaning And Maintenance; Technical Data - Toolland TM 76025 Mode D'emploi

TM 76025
shown.

Tighten screw firmly.

To remove the guard, proceed in reverse
order.

Never use the machine without guard.
MOUNTING AND REMOVING A GRINDING
WHEEL

Place the machine on a table, guard up.

Fit the spacer onto the spindle.

Place the grinding wheel on the spacer.

Screw the tension nut onto the spindle.

Press the lock knob and firmly tighten the
tension nut using the spanner supplied.

Release the lock knob.

To remove the grinding wheel, proceed in
reverse order.

Prior to mounting or removing a grinding
wheel always unplug the tool.
MOUNTING AND REMOVING THE SIDE
HANDLE

Tighten the side handle in one of the
mounting holes.
SWITCHING ON AND OFF

To run the machine, slide the on/off-
switch in the direction of the grinding
wheel.

To switch off the machine, you slide the
on/off-switch back.

CLEANING AND MAINTENANCE

The machine does not require any special
maintenance.

Make sure that the ventilation openings
are kept clean. Especially when working
in a dusty environment.

Before removing dust always unplug the
tool.

Do not use brushes of metal or the like to
remove dust and avoid damaging the
internal parts.

TECHNICAL DATA

Voltage
Frequency
Power
No-load speed
Wheel diameter
Grinding
www.toolland.eu
V 230
Hz 50
W 500
Min-1 11000
mm 115
Spindle thread
Weight
Level of sound pressure measured according
to EN 60745 :
Lpa (sound pressure)
Lwa (Acoustic power) 102,1dB(A)
Take appropriate measures for the protection
of hearing.
GUARANTEE
Refer to the enclosed conditions for the terms
and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
English
M.14
kg 1,90
91,1dB(A)
k=3dB(A)
K=3dB(A)
8