Fein MM 700-1.7 Serie Mode D'emploi page 16

en
16
Cutter blades for automobile glazing
applications (figure 5).
Guide the straight, bent or offset cutter blades
at a right angle to the window flange;
blade A – D.
For U-shaped cutter blades, pay attention that
the traverse of the cutter blade is led parallel
to the window pane of the vehicle;
blade E – F.
A
E
B
F G
The scraper knife is used for cutting back
bond remainders on the window flange or the
pane. Before re-bonding the vehicle window,
cut back the remaining bead to a height of
approx. 2 mm; blade G.
Cutter blades marked with a symbol may only
be operated as indicated.
C
Symbol on the cutting blade
Fig. 5
D