Input Connections - QSC WL 2102 Manuel De L'utilisateur

Input Connections

The input connectors are a pair of Neutrik NL8's wired in parallel. Connections for biamp and tri-
amp vary, see Table 1. The pin designations for the NL8FC cable connector is shown for reference,
bottom right.
Note! In three way mode, the Low Frequency Select switch position determines the
input connector wiring! Unexpected results may occur if switch positions and wir-
ing are not strictly controlled.
The WideLine loudspeaker is not equipped with a crossover network. All signal
processing must be done before connecting audio power to the loudspeaker. Do
not connect full-range audio to the high-frequency transducer or damage may
result!
Table 1: Input Connector Wiring, Two way and Three Way Modes
Two Way
Internal Shading
Pin Network Inserted in
Signal Path
1+ LF +
1- LF -
2+ Not Used
2- Not Used
3+ Not used
3- Not used
4+ HF +
4- HF-
Neutrik NL8FC Cable Connector Pinout
Below is a diagram showing the pin designation inside the Neutrik NL8FC connector. This informa-
tion is for reference only. Diagram is of the connector as viewed from the wire-insertion end.
NL8FC pin designations- Plug
viewed from the wiring side.
All manuals and user guides at all-guides.com
Three Way
Use External
Processing for
Shading, LF Select
Switch Position A
LF A +
LF A -
LF B +
LF B -
Not used
Not used
HF +
HF-
Three Way
Use External
Processing for
Shading, LF Select
Switch Position B
LF B +
LF B -
LF A +
LF A -
Not used
Not used
HF +
HF -
EN
5