Listening To Dab - auna DigiPlug UP Mode D'emploi

LISTENING TO DAB

The unit scans all available stations in DAB mode. Select the DAB function
with the mode button (1a)
1 Press the SCAN button (1b) and the system will begin full scanning of all
available DAB stations.
2 The received station remains in the station list after the scan. Press
the Up/Down button (8f) on the remote control to select your favorite
station in the station list and press the ENTER Select button (8g) to
confirm your selection.
Manual Tuning
1 Press and hold the Menu button (8b) on the remote control until it
switches to Menu mode.
2 Then press the Up/Down Button (8f) to select 'Manual Tuning' and press
the ENTER Button (8g) to confirm.
3 Press the Up/Down Button (8f) to scroll through the channel and press
the ENTER Button (8g) to confirm your selection.
Display Info
When you press and hold the Menu/Info button (8b) on the remote control,
the LCD display shows information such as RDS information from board
casting, time and date, etc.
.
DRC value (Dynamic Range Control)
You can set the compression level of the station to eliminate the differences
in dynamic range or audio level between radio stations.
1 Press the Menu button (8b), then press UP/DOWN (8f) to select 'DRC',
then press ENTER (8g) to confirm.
2 Press the Up/Down button (8f) to select the desired DRC level and
press the ENTER button (8g) to confirm your selection.
Note : Repeat the above procedure in the DAB menu, you can select and set
the following: <Station Order>, <Cut Inactive Station> & <System Setup>.
EN
19