OPERATION
1. If desired, insert preformed coin wrappers inside of the coin tubes and push the rows back into place. Lift Coin Fence to pull
out the 2nd row of the coin tube.
2. Plug in power cable and turn power switch on.
NOTE: Make sure all coin tubes are pushed all the way back.
When the machine power is turned on, the rotating plate will automatically move to the initial position as
per Figure 1.
To activate or stop rotation for feeding coins, press Run/Stop button.
3. Press the RUN/STOP button to start the machine. You will begin to hear a ticking mechanism.
4. Place coins into the hopper to begin sorting. The coins will automatically start to sort into the front row.
5. When a tube in the front row is full, the machine will stop sorting and the LCD Display will indicate which
coin tube is full by showing a blinking letter either T,L,Q,N,P,D (toonies, loonies, quarters, nickels, pennies, dimes).
6. When a tube in the front row is full, pull the tube tray where the full tube is located forward. The machine will automatically
begin sorting again.
NOTE: The display will reset the number of coins. The total dollar amount will not reset and will continue assign where it left off.
7. While the coins continue sorting, remove the full tube from the tube tray. Then push the wrapper up from the exposed bottom
edge. Pull out the wrapper and fold over the edges. Replace with a new coin wrapper and reinsert into the tube tray. Filled
wrappers are ready for storage or bank deposit.
8. When a coin tube in the back row is full, the machine will stop sorting and the LCD Display will indicate which coin tube is full by
showing a blinking letter either T,L,Q,N,P,D (toonies, loonies, quarters, nickels, pennies, dimes). When a tube in the back row is
full, remove it and replace with a new wrapper. Lift Coin Fence to pull out the 2nd row of the coin tube. Push the tube tray all
the way back in to continue sorting.
9. Repeat steps 1-9 when needed for all coin tubes.
10. To reset the display press the CLEAR button. When you are finished sorting press the RUN/STOP button to stop the machine
and turn the power switch off.
At any time during or after sorting, you can view the total dollar amount or the individual coin count of the coins you sorted by
pressing the mode button.
NOTE: When using wrappers that are not preformed:
1. Allow coins to fall directly into the coin tubes. Do not place flat wrappers into the coin tubes while sorting. This may
cause a jam.
2. Remove the coin tube when it becomes full.
3. Hold the coin wrapper; slide it gently over the top few coins in the tube.
4. While gently pushing the coin wrapper toward the bottom of the tube, tilt the coin tube so that the coins slide into the wrapper.
5. Turn the coin tube upside down and remove the coin-filled wrapper. Fold over the other end of the wrapper.
FS2D-CA-N manual.indd 8
8
Figure 1.
2011-8-22 8:25:35