Key To Symbols; Symbols On The Machine; Symbols For Canada Model; Symbols In The Operator's Manual - RedMax G5300 Manuel D'utilisation

Symbols on the mac hine:
W ARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must
be used to operate the chain saw.
Never operate a chain saw
holding it with one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Decompression v alve: The valve is to
reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
Air pur ge: Device that evacuates air
from the fuel system and make
starting the engine easier.
Symbols f or Canada model:
Recommended cutting
equipment in this example:
- Bar length 18 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 33 SL
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
2 – English
KEY T O SYMBOLS
Symbols in the operator' s
manual:
Switch off the engine b y moving the stop
switch to the STOP position before
carrying out any checks or
maintenance.
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar up
and towards the operator. May cause
serious personal injury.