Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - RedMax G9000 Manuel D'utilisation

Symbols on the machine:

WARNING! Chainsaws can be
dangerous! Careless or improper use
can result in serious or fatal injury to
the operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be
used to operate the chainsaw.
Never operate a chainsaw holding it with
one hand only.
Never let the guide bar tip come in
contact with any object.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar up
and towards the operator. May cause
serious personal injury.
Recommended
cutting equipment in
this example: - Bar
length 18 inches -
Max. nose radius 11
Teeth - Chain type
RedMax H42
Chain brake, activated (right) Chain
brake, not activated (left)
Decompression valve: The valve is to
reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
2 – English

KEY TO SYMBOLS

RedMax H42
Max 11T
18
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Adjustment of the oil pump
Refuelling.
Chain oil fill.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
Symbols in the operator's
manual:
Switch off the engine by moving the
stop switch to the STOP position before
carrying out any checks or
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake must be engaged
when the chainsaw is started.