Cleaning And Maintenance - Klarstein 10021651 Mode D'emploi

The following is not considered faulty operation:
• If your water is very hard (containing abnormally high levels of minerals) the humidifi er may
produce white dust. This is not a malfunction. The solution would be to clean the fi lter more often
or use softer water.
• If you stand very close to the humidifier, you will hear the gurgling sound of water. This is normal.
• The machine operates very quietly but it is not completely silent. Noise levels less than 35db is
considered normal.
WARNING!
lf the above recommended solutions do not work, please contact professional technical
support. Do not attempt to disassemble, repair and reassemble the machine as it may void the
warranty.
You can ensure many years of trouble free operation of your SPS—807 humidifi er by following a few sim-
ple maintenance procedures. If your water is hard. containing high concentrations of calcium and other
minerals, then over a period of time white dust will start to deposit on the various surfaces in the room.
A white, film-like substance will also start to develop in the water basin, on the transducer and on the
inner surface of the water tank. This white fi lm will impede the proper function of the transducer and the
operation of the machine.
We recommend the following:
1. lf your water is very hard. we recommend that you boil it fi rst allow it to cool completely before use
in the humidifi er. The boiling will reduce the mineral concentration in the water. The other option
is to use distilled water if your mineral level is still too high.
2. lf you are using the machine on a daily basis, clean the transducer, water tank and basin once a
week.
3. When the water tank needs a refi ll, empty the remaining water from the tank and fi ll it with fresh
water.
4. Clean the whole machine and make sure to keep all the parts completely dry when the machine
is not in use.
How to clean the transducer:
1. Place 510 drops of vinegar on the surface of the transducer and wait for 2-5 minutes.
2. Using a small brush, cotton swab or tooth brush. gently clean the mineral fi lm from the surface
of the transducer.
3. Rinse the transducer with clean water.
4. Never use sharp or solid objects for cleaning the transducer 4. Never use sharp or solid objects for cleaning the transducer

Cleaning and Maintenance

16