Blowing; Powertool Vacuuming; Cleaning/Maintenance; Cleaning & Maintenance - Parkside PNTS 1500 B3 Traduction Des Instructions D'origine

GB
the appliance off, remove the plug
from the socket and empty the con-
tainer (see Cleaning/Maintenance).
If foam or liquid exits, switch off
the machine immediately.

Blowing

To use the blower function, screw the
vacuum hose (18) on to the nozzles on the
engine housing (3) (operation without the
use of filters).

Powertool vacuuming

The Powertool hose can be used for
the following:
• Cleaning hard-to-reach places or sensi-
tive equipment.
• Connecting powertools for vacuuming
dust off.
Place the thicker end of the powertool hose
(19) straight onto the vacuum hose (18)
and the other end onto the reduction adap-
tor (20) supplied. You can now fit vacuum
nozzles or an electrical tool.
The reduction adaptor also fits onto
the vacuum hose (dust vacuuming
without the powertool hose).

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.
Never hose the appliance
down with water. Never use
aggressive cleaning agents
or solvents. This could dam-
age the appliance.
12
• After use, empty the waste tank (
5). Opening the drain plug to allow the
vacuumed liquid to drain out (
• Clean the waste tank with a damp cloth.
• Wash the foam filter with lukewarm
water and soap, and allow to dry.
• Beat the dust out of the cloth filter
( 11) and clean it with a paint brush
or hand brush.
• Replace the paper filter bag (
when full (see "Replacement parts/Ac-
cessories" for reordering)
• Always check the appliance before
use for any obvious faults such as a
defective mains cable, and have these
repaired or replaced.

Cleaning the filter insert

Check the filter insert for dirt once or twice
per year.
1. Open the cover (27) on the mo-
tor head (3):
Closure upward in
position
Remove the cover.
2. Take the filter insert (28) out of
the cover (27).
3. Wash the filter insert (28) with
lukewarm water and soap and
leave it to dry.
4. Place the filter insert (28) in the
cover (27) and reclose it:
Closure downward
in position

Storage

1. To store the mains cable on the back
of the device, pull out the top cable
holder (29a) and turn the bottom cable
holder (29b) outwards.
7).
12)
OPEN
CLOSE