Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
NOTE: When in a Resistance setting and the test leads are open
(not connected across a resistor), or when a failed resistor is under
test, the display will indicate O.L. This is normal.
DO NOT attempt to measure resistance on a live circuit.
DIODE TEST
1. Insert RED test lead into V jack
into COM jack
Continuity/Resistance/Diode/Capacitance
NOTE: The meter defaults to Continuity testing in this mode. To
enter Diode testing mode, press the "SEL" button
Diode icon
2. Touch test leads to diode. A reading of 200-700mV on display
indicates forward bias, "OL" indicates reverse bias. An open
device will show "OL" in both polarities. A shorted device will
show approximately 0mV.
14
OPERATING INSTRUCTIONS
Black lead
Red lead
, and rotate function selector switch
4
will appear on the display.
Black lead
Red lead
, and BLACK test lead
5
setting.
11
to the
2
twice. The
Publicité
Table des Matières
