Diodetest - Klein Tools CL390 Manuel D'utilisation

ENGLISH
CAPACITANCE
1. Insert RED test lead into VΩμA jack 5 , and BLACK test lead into COM
jack 4 , and rotate function selector switch 2 to the Continuity/
Resistance/Capacitance/Diode-Test
NOTE: The meter defaults to Continuity testing in this mode. To measure capacitance,
press the "SEL/NCV" button 12 repeatedly until nF appears on the display.
2. Remove power from circuit.
3. Measure capacitance by connecting test leads across the capacitor.
The meter will auto-range to display the measurement in the most
appropriate range.
Black lead
DIODE TEST
1. Insert RED test lead into VΩμA jack 5 , and BLACK test lead into COM
jack 4 , and rotate function selector switch 2 to the Continuity/
Resistance/Capacitance/Diode-Test
NOTE: The meter defaults to Continuity testing in this mode. Press the "SEL/
NCV" button 12 repeatedly until the diode icon
Touch test leads to diode. A reading of 200-800mV on display indicates
forward bias, "OL" indicates reverse bias. An open device will show "OL" in
both polarities. A shorted device will show approximately 0mV.
Black lead
μA DC CURENT (LESS THAN 200 μA)
1. Insert RED test lead into VΩμA jack 5 , and BLACK test lead into COM
jack 4 , and rotate function selector switch 2 to the
DC μA setting. The "μA" and "DC" icons will appear on the display.
2. Remove power from circuit and open circuit at measurement point.
3. Connect test leads in series with the circuit.
4. Apply power to the circuit to take the measurement.
Black lead Red lead
14
OPERATING INSTRUCTIONS
Red lead
Red lead
setting.
setting.
appears on the display.
attempt to
measure more
than 200μA.
DO NOT