Cleaning Tools - Hoover TurboPOWER Manuel De L'utilisateur

1 3
Hard surface floor
cleaning
The power nozzle can be used for
1 3
cleaning hard surface floors such
as wood, linoleum, vinyl, asphalt and
rubber tile, sealed cork, concrete and
terrazzo, as well as carpet.
To set the power nozzle for hard surface
floor cleaning, push the floor surface
selector button toward "BARE" (B). This
setting provides suction and no agitator
action. If you prefer, you may use the
wall/floor brush to clean bare floors.
You will find it particularly convenient
when cleaning lightweight area rugs to
set the floor surface selector button on
"BARE" and continue cleaning the sur-
rounding floor surfaces.
NOTE: The headlight will be ON in both
the "RUG" and "BARE" floor surface
modes.

Cleaning tools

The cleaning tools are conveniently
stored in the cleaner underneath the tool
lid. Pull up on edge of lid in recessed
area to open.
The lid is also designed with a "break-
away" feature which allows it to snap off
if it is pushed open too far. To re-attach,
align small knobs on hinge area of lid
with slots at rear of cleaner; press lid
back into place.
The cleaning tools have many uses.
best suited for the cleaning task from
the descriptions at left.
1 4
B
Brushed edge cleaning
B rushed edge cleaning is pro v i d e d
1 4
on both sides of the nozzle to
remove embedded dirt in carpet near
b a s e b o a rds and furn i t u re. Guide side of
nozzle parallel to edge of carpet or furn i-
t u re as shown.
1 6
A
B
D
Select the proper tool
A. Crevice tool may be used in
1 6
tight spaces, corners, and along
edges in such places as dresser draw-
ers, upholstered furniture, stairs and
baseboards.
B. Furniture nozzle may be used for
upholstered furniture, draperies, tapes-
tries, mattresses, clothing, automobile
interiors and carpeted stairs.
C. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters and registers.
D. Hard floor tool may be used for
walls and very irregular hard surface
floors such as brick and slate.
1 5
Suction regulator
1 5
when necessary. Open the suction reg-
ulator for less suction when cleaning
lightweight fabrics or throw rugs. Close
(A) the suction regulator for maximum
suction.
If the power nozzle is difficult to push
on some carpet, open the suction reg-
ulator. This will help prevent damage
to the belt.
1 7
C
How to connect
1 7
hand grip.
Tools may be attached directly to the
hand grip. With the latch in the unlock
position, insert tool (or wand if extra
length is needed), then push latch to the
lock
To remove the tool (or wand), push the
latch to the unlock
A
The suction regulator on the wand
allows the user to reduce suction
To use the cleaner with tools, dis-
connect the power nozzle from the
position to secure.
position.
Continued
5