Hoover TurboPOWER Manuel De L'utilisateur page 7

2 4
Carefully pull out used bag.
2 4
2 7
How to attach bag lid
The bag lid and hinges are
2 7
designed with a "break- away" fea-
ture. If the lid is pushed open too far, it
will come off. It can be easily re-
attached by aligning the hinges with the
appropriate slots in the cleaner, as
shown.
2 5
Slide bag collar of new bag firmly
2 5
into holder.
2 8
Filters-
secondary and micro
How to clean
Disconnect cleaner from electrical
outlet.
The secondary filter, located
2 8
behind the grill in the bag compart-
ment, protects the motor from dirt parti-
cles. If filter becomes dirty, pull off grill
and lift out filter. Wash filter in war m
water or replace it with a new one. A
dry filter must be put back into cleaner.
Do not operate cleaner without sec-
ondary filter in place.
B
2 6
Fit sides of bag into bag cavity
2 6
below seal (A).
Clear bag opening (B) by pushing the
pierced paper through opening toward
bag interior.
Close bag lid.
2 9
The micro filter aids in the filtration
2 9
process to return clean air to the
room. To remove this filter, open tool lid,
remove dusting brush and pull up red fil-
ter cassette.
Continued
A
7