Carpet Height Adjustment; Cleaning Tools - Hoover ELITE REWIND Guide De L'utilisateur

2-4
Transporting cleaner
To move your cleaner from room to
room, put handle in upright position, tilt
cleaner back on rear wheels and push
forward.
2-7
Carpet height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (A).
When it is necessary to raise and
lower the nozzle for various carpet pile
heights, place handle in upright position
and turn the nozzle control knob (B) to
the desired setting.
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position.
2-10
Stair cleaning
Use the hose and for stair cleaning.
Clean from bottom to top.
When using cleaning tools, the
agitator will continue to rotate.
CAUTION: To avoid personal inju-
ry or unnecessary wear to
carpet, and to prevent the cleaner
from falling, always place it at
bottom of stairs.
2-5
Carrying cleaner
The cleaner can also be moved by using
the carrying handle, located on the top
of the dirt cup.
2-8
B
A
Settings
For maximum cleaning perfor-
mance, the following carpet height
settings are recommended:
• Lowest setting: for all types of
carpet and hard surface flooring.
Note: If the cleaner is difficult to push,
turn knob to the next higher setting.
• Higher settings: for very deep pile
carpet, where easier pushing effort is
desired, while maintaining good clean-
ing performance.

Cleaning tools

Tools allow for cleaning surfaces above
the floor and for reaching hard to clean
areas.
The cleaner is ready for tool use when
handle is in upright position.
CAUTION: The agitator continues
to rotate while cleaner handle is
in upright position. Avoid tipping
cleaner or setting it on furniture,
fringed area rugs or carpeted
stairs during tool use.
2-6
Handle positions
The handle of your cleaner has three
positions; upright for storage and
when using cleaning tools; operating
position for general operation on car-
pet and floors; low for reaching under
low furniture. Step on handle release
pedal to lower handle.
2-9
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) as shown and will prevent
rug from clinging to cleaner. Continue
to lift up nozzle so that when you have
reached the edge, it is completely
off the rug. Move cleaner back to start
again, lower nozzle, and use only for-
ward strokes.
How to clean tools
To clean the hose, wipe off dirt with a
cloth dampened in a mild detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air dry
before using.
5