Trevi DAB 792 R Mode D'emploi page 4

ENGLISH
10
11 12

1. Button
2. STANDBY/MODE button
3. SCAN button
4. MENU/INFO button

5. Button
6. SELECT/SNOOZE button
7. VOLUME knob
8. ALARM button
9. PRESET button
10. LCD Display
11. DAB/FM TELESCOPIC ANTENNA
12. BATTERY COMPARTMENT
13. HEADPHONE out
14. DC IN (5V)
15. ON/OFF SWITCH
GETTING STARTED
Before using your Radio for DAB or FM, fully extend the TELE-
SCOPIC ANTENNA (11) and position for the best reception.
Before connecting the power, check that the mains voltage
on the rating plate of the AC adaptor is same as the voltage
in your area.
Plug the DC cord from the AC adaptor into the DC IN (14)
socket on the back side of the unit.
Plug the AC adaptor into the wall socket and switch the mains
power on.
BATTERY OPERATION
1. Remove the Battery Compartment Cover (12) by gently
pushing the clips downward and outwards.
2. Install 4 x 'AA' size batteries (UM-3 or equivalent) and take
care that the correct polarities are observed.
3. Replace the battery compartment cover.
4
2 3
4
1 5
9
6
8
7
15
14 13
NOTE:
- If not use battery for long time, please take out the
batteries in case of damage caused by battery leakage.
- When battery is low, the screen will show Low power.
Please change batteries.
POWER ON/OFF
When push the ON/OFF SWITCH (15) on the back of the de-
vice to ON side (OFF side, power-off ), the device will start up
and show "Welcome to Digital Radio". Then it will enter into
standby mode. If pressing the STANDBY/MODE (2) button, it
will enter into the mode displayed last time.
STANDBY MODE
Under radio mode, press and hold the STANDBY/MODE (2)
button to switch to standby mode.
Under standby mode, press the STANDBY/MODE (2) button to
switch to radio mode.
Under radio mode, press STANDBY/MODE (2) to switch DAB-
FM.
VOLUME SELECTION
Under radio mode, knob the VOLUME (7) to adjust the
volume.
TIME SETTING
Under radio mode, if press and hold MENU/INFO (4) button,
will show "Set Menu". Press
Date", "System version", "Factory reset", "FM Scan Setting". Then
press SELECT/SNOOZE (6) button to enter into corresponding
function setting.
A. Set Time/Date: Select Time/Date to set Hour->Min->Year-
>Month->Date and press SELECT/SNOOZE (6) button to
confirm.
B. System Version: This only allows to check, but not allow
to set.
C. Factory reset: press SELECT/SNOOZE (6) button to enter,
and press or to select No/Yes. If confirm yes, the data like
time/date, alarm and preset stations will disappear.
D. FM Scan setting: press SELECT/SNOOZE (6) button to
enter Station Strong interface
Only: it will only search and display stations with good
signal.
All: it will also search and display stations with weak
signal.
ALARM SETTING
Under radio mode, press ALARM (8) button to enter Alarm


Setup. Press (1) or (5) to select Alarm 1/Alarm 2 OFF/ON.
If select ON, press SELECT/SNOOZE (6) button to save the set-
ting. Press MENU/INFO (4) button to return to previous menu.
When alarm ring, press Alarm button to cancel.
A. Alarm 1 setting
- Under radio mode, press ALARM (8) button to enter
Alarm 1 Setup and press SELECT/SNOOZE (6) button to
DAB 792 R


(1) or (5) to select "Time/