Technical Specifications; Disposal Of Old Electrical Appliances - cecotec FORCE CLIMA 12750 Manuel D'instructions

ENGLISH
The air conditioning is not placed
Loud noise
on a flat surface.
Compressor
Overheat protection starts.
does not work
The distance between the device
and the remote control is too far.
The remote
The remote control is not in line
control does
with the direction of the remote-
not work
control receiver.
Batteries are dead.
Displays 'E2' The pipe temperature sensor is
abnormal.
Displays 'E1' The room temperature sensor is
abnormal.
Note: If your problem is not listed in the table, or the recommended solutions do not work,
contact Cecotec Technical Assistance Service.

9. TECHNICAL SPECIFICATIONS

Product reference: 05266/05268
Product: Force Clima 12750/14750 Cold & Warm Connected
Power: 220-240 V~
Voltage: 50 Hz

10. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old appliances
must be collected separately, in order to optimize the recovery and recycling
of the materials they contain and reduce the impact on human health and
the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your
28
FORCE CLIMA 12750 COLD&WARM CONNECTED / FORCE CLIMA 14750 COLD&WARM CONNECTED
Put the unit on a flat and hard place
(to reduce noise).
Wait for 3 minutes until the
temperature is lowered, and then
restart the unit.
Let the remote control get close
to the unit, and make sure that the
remote control directly faces to
the direction of the remote-control
receiver.
Replace batteries.
Contact Cecotec's Technical Support
Service.
Contact Cecotec's Technical Support
Service.