Technical Specifications; Disposal Of Old Electrical Appliances - cecotec FORCE CLIMA 12500 COLD&WARM Manuel D'instructions

There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
The cooling
mode, there are other sources of
effect is not
heat.
good
The filter net is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed
Loud noise
on a flat surface.
Compressor
Overheat protection starts.
does not work
The distance between the device
and the remote control is too far.
The remote
The remote control is not in line
control does
with the direction of the remote-
not work
control receiver.
Batteries are dead.
Displays 'E2' The pipe temperature sensor is
abnormal.
Displays 'E1' The room temperature sensor is
abnormal.
Note: If your problem is not listed in the table, or the recommended solutions do not work,
contact Cecotec Technical Assistance Service.

8. TECHNICAL SPECIFICATIONS

Product reference: 05259/05267
Product: ForceClima 12500 Cold & Warm / ForceClima 14500 Cold & Warm
Power: 220-240 V~
Voltage: 50 Hz

9. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances must
FORCE CLIMA 12500 COLD&WARM / FORCE CLIMA 14500 COLD&WARM
Pull the Curtain.
Close doors and windows and add
new air conditioning.
Clean or replace the filter net.
Clear obstructions.
Put the unit on a flat and hard place
(to reduce noise).
Wait for 3 minutes until the
temperature is lowered, and then
restart the unit.
Let the remote control get close
to the unit, and make sure that the
remote control directly faces to
the direction of the remote-control
receiver.
Replace batteries.
Contact Cecotec's Technical Support
Service.
Contact Cecotec's Technical Support
Service.
ENGLISH
25