cecotec FORCE CLIMA 12750 Manuel D'instructions page 28

Do not use abrasive scouring pads, powders or cleaners.
Clean the filter once every two weeks.
To clean the filter net and the CON filter, unscrew the screw fixed on the back and take the net
out. Wash it with warm water and neutral detergent (about 40ºC / 104ºF) and dry it. Clean the
net with a damp cloth.
To clean the filter net and the EVA filter, press both upper flaps and remove it. Wash it with
warm water and neutral detergent (about 40ºC / 104ºF) and dry it. Clean the net with a damp
cloth.
8. TROUBLESHOOTING
Do not repair or disassemble the air conditioning by yourself. Unqualified repair will lead to
failure of the warranty card and may cause damage to users or their properties.
Problems Reasons
There is no electricity.
The overflow indicator displays
"FL".
The room temperature is too low
or too high
The air
conditioning
In cooling mode, the room
does not work
temperature is lower than the set
temperature; in heating mode, the
room temperature is higher than
the set temperature.
In dehumidification mode, the
room temperature is low.
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
The cooling
mode, there are other sources of
effect is not
heat.
good
The filter net is dirty.
The air inlet or outlet is blocked.
FORCE CLIMA 12750 COLD&WARM CONNECTED / FORCE CLIMA 14750 COLD&WARM CONNECTED
Solutions
Turn the device on after connecting
it to a socket with electricity.
Discharge the water inside.
We recommend that you use the
device in a temperature of 7-35 ℃
(44-95 ℉).
Change the set temperature.
The device is placed in a room with
an room temperature higher than 17
℃ (62 ℉).
Pull the Curtain.
Close doors and windows and add
new air conditioning.
Clean or replace the filter net.
Clear obstructions.
ENGLISH
27