COMENDA Hi-Line HB Serie Instructions Pour L'utilisation Et L'entretien page 30

ENGLISH
H3
INSUFFICIENT WASH WATER TEMPERATURE
This alarm is displayed if, during the cycle, the wash
phase is carried out at least 10°C lower than
the set temperature.
F1
DOOR OPEN WARNING
This warning is displayed when the door is open.
It remains displayed until the door is closed
F2
INITIAL WATER FILLING
This warning is displayed when the machine is
FILLING (only during regulation)
(only with "starting temperature management"
active).
F3
CORRECT TANK FILTER POSITION
This warning is displayed when the filter is
not fixed properly in place
C1
SELF-WASHING CYCLE
This warning is displayed when the machine is
carrying out the SELF-WASHING cycle
SANITIZING
10
11
12
28
Part 3: Reserved for Author. and Qualified Techn.
H3
F1
F2
F3
C1
13
3.3 PERISTALTIC DETERGENT/RINSE
AGENT DISPENSER PUMP (FIG. 8)
The machine is equipped with an automatic detergent and
rinse agent dispenser pump.
Dispensing of detergent and rinse agent is managed both
during the regulation and restoration phases. The amount of
detergent/rinse agent is identified during the installation phase
by the authorised technician and is suited to the water volume
and hardness. At each rinse cycle, the machine restores
the detergent and rinse agent values foreseen by the
manufacturer
To fill the dispenser, proceed as follows:
• Insert the supply tube (11/13) in the tank (10/12).
• Start the machine and check that the dispenser draws
from the tank
• The dispenser is filled during the cycle by slightly opening
and closing the door, a few times, until you see that the
tube is completely filled.
ATTENTION
If
the detergent comes in contact with skin, wash with plenty
of running water or, more precisely, refer to the specific
indications according to the type of detergent used.
• The detergent enters automatically every time the tank
is filled with water.
• Water droplets on glass indicate insufficient dosage,
while stripes or dotting indicate excessive dosage.
• To adjust dosage, act on the pin, rotating it clockwise
to decrease the amount and anticlockwise to increase.
IMPORTANT
T
hese data are indicative and not binding, as they can
change depending on the hardness of the water, and the
type of detergent and rinse agent used.
ATTENTION
If
you change the product used (detergent or rinse agent)
it is recommended to wash the dispensing system with
water and then to fill the dispensers.