COMENDA Hi-Line HB Serie Instructions Pour L'utilisation Et L'entretien page 16

ENGLISH
2.1.c STARTING WASH CYCLE
IMPORTANT
T
he selection of starting MANUAL or AUTOMATIC
cycle must be made by an authorised technician.
STARTING AUTOMATIC WASH CYCLE
To start the wash cycle in AUTOMATIC mode (with
opening and closing of the door), the cycle start mode
must be changed
IMPORTANT
T
his operation must be carried out by an authorised
technician during installation.
STARTING MANUAL WASH CYCLE
To start the wash cycle, touch
the START key.
The START key turns BLUE
during the entire duration of the
wash cycle.
The phase and progress bar
of the cycle are viewed on the
display.
The following phases are di-
splayed during execution of
the cycle:
° WASH
° PAUSE*
° RINSE
* DRAIN
(only in HR versions)
ATTENTION
It is recommended to check the level of the detergent
and rinse agent daily.
TERMOSTOP
F
or hygienic purposes, machine operation always achie-
ves the ideal rinsing temperature. If the temperature is
not sufficient, washing is prolonged automatically until
the conditions necessary for ideal rinsing are achieved.
The pause to reach the ideal temperature can be prolon-
ged to a maximum of 8 minutes. When the water in the
boiler is not at the proper temperature, the cycle progress
bar and the ACTUAL and SET rinse water temperature
are viewed on the display.
14
2.1.d Interruption of the cycle
The wash cycle can be interrupted temporarily in
two ways:
1) by opening the door acting
as EMERGENCY.
F1 DOOR OPEN appears on
the display.
When the door is reclosed, the
cycle resumes from where it
stopped.
2) By pressing the START but-
ton during the cycle, the wash
START START
phase guarantees a minimum
washing time.
At the end of the wash cycle, the
cycle carried out and READY
to GO appear on the display
and the START key lights ups
WASH
STEADY GREEN.
At the end of the wash cycle, remove the dishrack and
DRAIN
shake it likely to remove the last drops remaining on the
washed items.
Leave the objects to try and remove them from the di-
RINSE
shrack with clean hands.
Set everything on hygienic and surely stable surfaces.
2.1.e DRAINING WATER FROM THE TANK
2.1.e .1 Drain for machines without drain pump
The water in the tank can be emptied at any time of the
day depending on the filth accumulated.
To perform this operation,
proceed as follows:
- SWITCH OFF the dishwasher
by setting the START key at OFF
OFF appears on the display
- Release the overflow (14)
allowing the water to drain
completely from the tank;
- Extract the tank filters
(15/16/17) and clean them.
At the end of the cycle, put
the filters (15/16/17) and the
overflow (14) back into the
respective seats.
Part 2: Reserved for Operator
START START
DOOR OPEN
F1
START START
ECO
READY TO GO
START START
OFF