Installation Instructions - Eneo IED-62F0036M0A Mode D'emploi

Installation instructions

1. Drill four holes for mounting on the ceiling or wall.
2.
mounting screws.
3. Route the power & ethernet cable to the connecting place.
4. Adjust the camera's viewing angle (Pan, Tilt, Rotation)
5. Assemble the dome cover to the dome base unit.
CAUTION:
Extreme care should be taken NOT to scratch the lens and the
bubble dome surface while the camera installing or adjusting.
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area. Do not expose the camera direct-
ly to a strong light source such as the sun or spot light.
Plastic Anchor (6.5x26.6mm)
Mounting Screw (4x25mm)
EN
7