Salda STOUCH Notice Technique page 9

B1 B4 B6 Review and
L4-L7
cancel alarms
and warnings
Functional
B1 B4 B6
Review
B1
CO blow off
L2-L7
2
On/off
B2 B3 B5 "Child safety
feature"
7. CONNECTION INDICATION
Flashing „Con" – connecting.
Shining „noC" – connection lost or there is no connection with the controller.
NOTE: This paragraph applies when the controller is used as a Modbus master.
8. FAN SPEED CONTROL OPTIONS
• Selecting 4 preset speeds;
• Selecting percentage value of speed (0,20 - 100 %) only for 0...10 VDC output and ECO controller;
• User menu speeds are set in intervals of 5 %;
• Service menu speeds are set in intervals of 1 %;
• Operates in 4 speeds, the values of which are displayed on Stouch in Pascals (Pa).
NOTE: the function is available when fan and pressure sensor are connected to Stouch.
STOUCH v2019.1
In case of failure L4, L5, L6, L7 are blinking
and failure codes appear on split screen
(A.01, A.02 and etc.). In case of warning,
warning codes (.01, .02 and etc.) appear
on split screen. List of errors and warnings
Press B2 and B3
can be reviewed by pressing B4 or B6.
for resetting
After clearing fault or warning signal remote
By pressing B1
controller returns into initial state. By pressing
faults are tempo-
B1 faults are not shown for one minute, thus
rary not shown.
permitting to adjust temperature and fan
settings.
Note: it's strictly forbidden to clear a fault
or warning without removing its cause. This
must be performed by the service represen-
tatives or maintenance personnel.
When the function is active, the segment
display shows functional codes. The list of
functional messages can be reviewed by
Upon pressing
touching B4 or B6 buttons. Upon pressing B1
B1 the functional
the functional codes are not displayed for one
codes are not dis-
minute, allowing manipulation of temperature
played temporarily
and fan settings.
NOTE: if failures are active, the functional
codes are not displayed!
L2, L3 and L7 are blinking, L4, L5, L6 are
By pressing B1
shining. Split screen shows "CO2". By press-
indication „CO2"is
ing B1 indication "CO2" is not shown for one
not shown tem-
minute, thus permitting to adjust temperature
porary.
and fan settings.
Press down B3, Non active elements B1, B4 and B6. After
B2 and B5 for 2 pressing unavailable button, segment display
seconds. shows "−−−"
EN | 9