Software Set Up - Analog way STUDIO SCAN XTD825 Manuel Utilisateur

Chapter 9 : CONTROL SOFTWARE (continued)

9-3. SOFTWARE SET UP

Select the Serial port in the Controls menu.
The STUDIO SCAN XTD825 / 625
In the Input menu:
- Select the input type (analogic or DVI).
- Set the H sync load of the input.
- Select "Yes" in the SOG Input section if your input is a RGsB (SOG) source.
In the Output menu, select an Output standard, an Output rate mode and the RGB/YUV output type.
PAGE 18
™
is now connected to the control device.
STUDIO SCAN XTD825 / 625™