Ignitor Lighting
• Do not lean over grill while lighting.
1.
Turn gas burner control valves to
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
To ignite, push and slowly (2-3 seconds) turn ANY knob to
hear the ignitor click.
5.
If ignition does NOT occur in 5 seconds, turn the burner controls off
5 minutes and repeat the lighting procedure.
6.
To ignite remaining burners, follow steps 4 and 5.
WARNING
Turn controls and gas source or tank OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls
minutes and repeat the lighting procedure. If the burner does not ignite with the
valve open, gas will continue to flow out of the burner and could accidently ignite
with risk of injury.
Match-Lighting
•
Do not lean over grill while lighting.
1.
Turn gas burner control valves to
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
For burners that cannot be reached through the match light hole, place match
into match holder and light match. Light burners by putting match through
grate bars and under heat tent with match holder. Immediately push in and turn
burner knob to the
HIGH position. Be sure burner(s) lights and stays lit.
USE AND CARE
(off).
HIGH. You should
, wait
off, wait 5
(off).
•
Putting out grease fires by closing the lid is not possible. Grills are well
ventilated for safety reasons.
•
Do not use water on a grease fire. Personal injury may result. If a grease fire
develops, turn knobs and LP cylinder off.
•
Do not leave grill unattended while preheating or burning off food residue on HI.
If grill has not been regularly cleaned, a grease fire can occur that may damage
the product.
Pa g e 8
CAUTION
C H A R B R O I L. C O M