Nilfisk Advance Adgility XPB Notice D'utilisation page 13

1. General overview of equipment:
Accessories shown in the illustrations may vary from model
to model.
2. Hose connection:
Fit the hose inlet sleeve into the opening on the upper lid.
Apply soft pressure and turn the inlet sleeve approximately
half a turn to ensure it is firmly secured. Turn clockwise to
lock, anti-clockwise to release.
3. Adjustment of strap position on support
plate:
On the primary strap, the position of the strap can be
adjusted for your individual comfort by moving the
adjustment plate to the inner or outer position.
4. Adjustment of tension ties on the strap's
support plate:
You can adjust the tension ties for your individual comfort.
Form a loop with your finger, then move the tie through the
clip forwards or backwards to the required length. Remove
your finger. Tension the tie.
5. Adjusting the vacuum cleaner to sit com-
fortably on your back:
Pick up the vacuum cleaner. Put your arms through the
shoulder straps. Snap the waistbelt clip shut. Adjust the
length. Snap the chest clip shut. Adjust the straps vertically
by pulling down on both straps as shown in the picture.
6. Tension tie clip:
Snap the two halves of the clip together. Make sure they are
securely fastened. To unlock, press both sides of the clip
simultaneously.
7. On/Off:
Press the power switch for ON or OFF.
8. Dust bag:
When the suction power diminishes, it is time to replace the
dust bag. Check the bag frequently to make sure that
you don't overfill. Release the latches on the upper lid.
Lift up the lid from the container. Take hold of the
cardboard part of the dust bag and carefully lift the bag out
of the container. Some types of dust bag can be sealed to
prevent any dust/rubbish from being released.
In that case: Remove the protection foil. Fold the card board
and seal the bag.
823 0100 100 Instruction for use Adgility XPB_US.indd 13 823 0100 100 Instruction for use Adgility XPB_US.indd 13
GENERAL INSTRUCTIONS FOR USE
9. Bag fi lter:
When you replace the dustbag it can be a good idea to
exchange or clean the bag filter. This can be done after you
have lifted out the dust bag. Clean the filter by shaking it
well. Put the bag filter into place or exchange it with a new
one if it's worn or damaged. Put a dust bag into place and
replace the upper lid and close the latches.
10. Pre fi lter:
Never vacuum without a pre-filter fitted into the machine.
Check and if necessary replace the pre-filter. Release the
two latches on the motor top. Remove the container and the
upper lid. Place the new pre-filter in the centre of the motor
top. Lock both latches down.
11. Exhaust fi lter:
The filter cleans exhaust air from the vacuum cleaner. Check
and change the exhaust filter frequently. Press the button
downwards and open the cover. Fit the exhaust filter into
the cover. Fasten to the lower edge of the cover. Close the
cover.
12. Connection of bent end and handle grip:
Push the handle grip into the bent end until it is properly
fitted.
13. Round brush nozzle:
Useful tool for cleaning home furnishings etc.
14. Combi nozzle:
One setting with brush (hard floors) and one without brush
for rugs (soft floors).
15. Crevice nozzle:
For cleaning tight spaces such as furniture, radiators,
corners and joints.
13
11-05-2009 08:53:57 11-05-2009 08:53:57