Remington R-9170 Guide D'utilisation Et D'entretien page 3

Cleaning your shaver:
TO ASSURE OPTIMAL PERFORMANCE,IT IS RECOM-
MENDED T H AT YOU CLEAN YOUR SHAVER AFTER EACH
USE.The cutting system of this shaver was designed t o
be cleaned by rinsing under warm running water or by
b r u s h i n g .
Cleaning your Remington shaver is easy.
® (NOTE: With the
R-9370 model,the brush icon will blink to remind you to clean
your shaver.)
Open the hairpocket by squeezing
on both buttons and rotating awa y
from the body of the shaver. You
may blow out the stubble thor-
oughly, or rinse the shaver head in
water. Rinse both sides of the
head assembly.
At Least Once a Week:
For more complete cleaning, remove the cutter retainer
a s s e m b ly from the hairpocket by turn-
ing the center knob ap p r o x i m at e ly 1/4
turn counter clockwise. Hold cutter
retainer assembly as shown, a n d
remove head by turning ap p r o x i m at e ly
1/8 turn in the direction shown. B r u s h
clean both the head and the cutter.
Reassemble head to cutter retainer assembly by align-
ing and turning head 1/8
turn in the opposite direc-
t i o n .R e p e at this process
for each of the 3 heads.
Clean each head and cutter
set one at a time to prevent
mixing cutter components.
(These should be kept as
s e t s ) . After cleaning, p l a c e
cutter retainer assembly in
the hairpocket, and secure by turning center knob
ap p r o x i m at e ly 1/4 turn clockwise.
Caution: Never put the shaver completely under water.
Do not use any aggressive cleansing agent as this may destroy the
shaver coatings.
To clean and lubricate your shaver's cutters and head assembly,
apply Remington ® Shaver Saver
helps remove hair clippings while reducing wear. A quick spray
after each shave keeps your shaver operating at peak perform-
ance.
Caution: Do not remove or replace the head assembly while
shaver is running or plugged into an electrical outlet as it may
cause damage to the unit's cutters.
Worn or damaged parts should be replaced with Remington
replacement parts only.
H a i r p o c k e t
Head
Cutter
® (SP-4) Lubricant.The lubricant
®
When is it time to replace your heads
and cutters?
It is very important to replace your heads and cutters
when necessary to insure a close,comfortable shave
without irritation. We recommend they be replaced
every 12 months.Here are some signs of head and
cutter wear, indicating that replacement is needed.
(NOTE:R-9370 cutter icon,R-9270- the yellow LED-
will blink when it is time to replace the cutters.)
Irritation
As the heads get excessively worn there may be some
skin irritation.This would be especially noticed when
applying After Shave lotion.
Pulling
When the cutters wear you may feel a sense of pulling
and a loss of closeness when you shave.This is an in
cation that it is time to replace your heads and cutters.
The replacement part for this shaver is model #SP-18 or SP-21.
U.S.residents: To order, contact us at 800-736-4648,visit us at
www.remington-products.com or visit your local retailer.
Canadian residents:For any shaver accessory requirements,
please call (800) 268-6531 or write:Remington Products
(Canada) Inc., P.O.Box 601,Postal Station "T,"Dept.A-100,
3019 Dufferin St., Toronto,Ontario,Canada M6B3T7.