Renkforce 752181 Notice D'emploi page 31

"SYSTEM STATUS" LED
Event
Operating voltage and battery voltage ok
Operating voltage not properly applied
Low battery voltage
Battery test
System is in standby
"ZONE 1 to 6" LED
Event
Alarm zone subject to error
Alarm zone ok
Alarm zone triggered alarm
Alarm was triggered caused by this alarm zone.
The alarm is now stored in the system.
The alarm zone was set to bypass operation
Acoustic signal sounds
Event
Outlet delay, inlet delay or standby mode active
Al alarm is active or was already active
Successful operation of button or battery voltage
is "OK" after a battery test
Error due to applied alternating voltage
Battery voltage is "Not OK" short beep after 30
seconds
LED
Lit
Flashes twice with a break of one second
Flashes thrice with a break of one second
Flashes
Flashes alternatingly with the "ZONE STATUS" LED
LED
Lit
Off
Flashes fast
Three flashes followed byshort break
Flashes slowly
Acoustic signal sound
Short beeps are audible with an interval of 0.5 se-
conds between them.
The beeps shorten to 4 beeps every three seconds
in the last 10 seconds of delay or standby.
One long beep signals the end of the delay or
standby
Four beeps per second
Two short beeps
1 beep at 30 second intervals
5 short beeps followed by 1 battery test
31