Servicing And Cleaning - M-E CUVEO CR-UPMS300 Mode D'emploi

can check the functioning of the wireless
flush-mount switch by briefly pressing the
corresponding "ON" button of the relevant
switch channel. LED (1) will flash red. The
switch contact at the middle terminals is
now activated and the mains voltage is con-
nected and an attached device will thereby
also be automatically switched on. Briefly
press the "OFF" button of the corresponding
switch channel on the transmitter, which will
prompt LED (1) to stop flashing, the mains
voltage at the centre terminals and the
device connected to it will be switched off.
OPERATION
Connect a device to the switch contact.
Please read the chapter titled "Technical
Details" to learn more about the
maximum capacity of the device.
Operating the corresponding "ON" or
"OFF" button of the switch channel on the
wireless transmitter will cause the switch
contact, and thereby the mains voltage
to the device, to be switched on (LED (1)
will flash) or off (LED (1) will go off).

SERVICING AND CLEANING

Servicing or repair works can only be
performed by a qualified person or at
a special service centre. There are no
components in the product that need
to be serviced. At no point must it be
opened or disassembled given the
danger of electric shock.
• The external surface can be cleaned by
using a dry, soft and clean cloth. Do not
press too hard on the front panel or on the
casing, as this can leave scratch marks on
the surface.
• Dust can be easily removed by using a soft
and clean brush with long hairs and bristles
and a vacuum cleaner.
EN
21