Initial Operation - M-E CUVEO CR-UPMS300 Mode D'emploi

mounted socket and before undertaking the
initial operation of the product.

INITIAL OPERATION

Configuring the wireless
flush-mount switch for a
wireless transmitter
a.) Plug the wireless flush-mount switch into
a regular 230 VAC mains voltage in the
manner indicated in the above section.
b.) Press button (2) until LED (1) flashes red.
c.) Before LED (1) stops flashing, press the
"ON" button of the desired switch channel
on the wireless transmitter for which the
wireless flush-mount switch is being
configured. The red LED (1) flashes. This
indicates that the configuration process has
been successfully completed.
Configuring the wireless
flush-mount switch for
several wireless transmitters
Up to 8 wireless transmitters can be
configured for the wireless flush-
mount switch.
a.) Plug the wireless flush-mount switch into
a standard 230 VAC mains voltage in the
manner indicated in the above section.
b.) Press button (2) until LED (1) flashes red.
c.) Before LED (1) stops flashing, press the
"ON" button of the desired switch channel
on the wireless transmitter, for which the
wireless flush-mount switch is being
configured. The red LED (1) light will
flash. This indicates that the configuration
process has been successfully completed.
d.) Repeat these steps for other wireless
transmitters.
EN
19