MSI 970A-G43 PLUS Mode D'emploi page 32

CPU Core Control [Auto]
f
This item allows you to select the number of active processor cores. When set to Auto,
the CPU will operate under the default number of cores.
DRAM Frequency [Auto]
f
Sets the DRAM frequency. Please note the overclocking behavior is not guaranteed.
Adjusted DRAM Frequency
f
Shows the adjusted DRAM frequency. Read-only.
DRAM Timing Mode [Auto]
f
Selects the memory timing mode.
[Auto] DRAM timings will be determined based on SPD (Serial Presence
Detect) of installed memory modules.
[Link] Allows user to configure the DRAM timing manually for all memory
channel.
[UnLink] Allows user to configure the DRAM timing manually for respective
memory channel.
Advanced DRAM Configuration
f
Press Enter to enter the sub-menu. This sub-menu will be activated after setting Link
or Unlink in DRAM Timing Mode. User can set the memory timing for each memory
channel. The system may become unstable or unbootable after changing memory
timing. If it occurs, please clear the CMOS data and restore the default settings. (Refer
to the Clear CMOS jumper section to clear the CMOS data, and enter the BIOS to load
the default settings.)
HT Link Speed [Auto]
f
This item allows you to set the Hyper-Transport Link speed. When Auto, the system
will detect the HT link speed automatically.
Adjusted HT Link Frequency
f
It shows the adjusted HT Link frequency. Read-only.
HT Link Control
f
Press Enter to enter the sub-menu.
fHT Incoming/ Outgoing Link Width
These items allow you to set the Hyper-Transport Link width. When Auto, the
system will detect the HT link width automatically.
Adjust PCI-E Frequency (MHz)
f
Sets the PCI Express frequency.
Unlock CPU Core [Disabled]
f
This item is used to unlock the CPU core. Please refer to the procedures below for
CPU core unlocked in BIOS setup.
22
BIOS Setup