Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.
LOADING NAILS
● When loading nails into Nailer,
1) do not depress trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Pull the nail feeder back until it latches
(2) Insert nail strips one by one from above the magazine.
Two strips can be loaded at one time.
(3) Press the stop lever and slide the nail feeder forward
until it contacts the nail strip.
WARNING
Nail Feeder
Nail Strip
Magazine
Stop Lever
Nail Feeder
NOTE:
● Quietly push the Nail Feeder against the nail.
If the Nail Feeder is released from backward
the magazine and bumped against the nail, the
connecting plastic of the nail can be damaged.
● Use nail strip at least 5 nails remaining.
● Set heads of nails overlapped as shown in the below
fi gure.
● Ensure that the head of tail nail is set under the nail
stopper of nail feeder.
Tail Nail
Nail Stopper
The Nailer is now ready to operate.
NAILER OPERATION
Read section titled "SAFETY" (pages 4 – 7).
● Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
English
DANGER
MUST
wear
safety
13
Publicité
Table des Matières
