Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPTIONAL ACCESSORIES
○ Sequential Trip Mechanism Kit (Code No. 878226)
○ Pneumatic Tool Lubricant
1 oz. (30 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change without any
obligation on the part of HITACHI.
APPLICATIONS
○ Installation of asphalt roofi ng shingles in building
contrcution.
○ Installation of insulation boards in building construction.
BEFORE OPERATION
Read section titled "SAFETY" (pages 4 – 8).
Make sure of the followings before operation.
WORKING ENVIRONMENT
● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.
AIR SUPPLY
● NEVER use reactive gases or
● Never
connect
which
potentially
(13.7 bar 14 kgf/cm
● Never use non relieving coupler on Nailer.
1. Power source
○ Use only clean, dry, regulated compressed air as a
power source for this Nailer.
... sold separately
(Code No. 877153)
(Code No. 874042)
(Code No. 876212)
WARNING
DANGER
other
bottled
Explosion may occur.
WARNING
Nailer
to
pressure
exceeds
200
) if a regulator fails.
2
○ Air compressors used to supply compressed air to
this Nailer must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries."
○ Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
○ Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
○ Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter ............ The fi lter removes moisture and dirt
Regulator ......The regulator controls the operating
Lubricator .... The lubricator supplies an oil mist to the
Nailer Side
gases.
3. Air hose
Compressed air supply hoses shall have a minimum
psi
working pressure rating equal to or greater than the
pressure from the power source if a regulator fails, or
150 psi (10.4 bar 10.6 kgf/cm
4. Air consumption
Using the Air consumption table and the Air
compressor size formula, fi nd a correct compressor
size.
).
2
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
pressure for safe operation of the Nailer.
Inspect the regulator before operation to
be sure it operates properly.
Nailer.
Inspect the lubricator before operation
to be sure the supply of lubricant is
adequate.
Use Hitachi pneumatic tool lubricant.
Regulator
Compressor Side
Filter
Lubricator
), whichever is greater.
2
English
11
Publicité
Table des Matières
