Sony WEGA KLV-17HR2 Mode D'emploi page 29

Bundling the cables
You can store the cables in the back of the TV.
1
Bundle the cables and pass the cables through
the centre hole.
2
Put the cable cover on the stand by fitting the
claws of the cover with the corresponding holes
on the stand. Then, push the cover to secure it.
To remove the cable cover, pull the
convex part of the cover towards you.
• It may not be possible to fasten cables that
are too thick with the cable cover.
• If all the cables cannot be stored inside,
leave some of them hanging down on both
sides of the TV.
GB
Cable
cover
Convex
(continued) (continued)
27
Installation